The Climatization is the main source of household consumption and therefore the Climatization module exists to help you manage these resources well and save energy.

The Climatization can control any type of HVAC equipment, including: air conditioning, boilers, central geothermal. The operation mode can be done by the eletric valves control, IR commands, power control or others. As temperature reading systems, you can use various types of thermal sensors and even iMeteo station.

1.In Mordomus iThink Home Menu press button: Configurations
2. In the window Climatization:
3. Select the Floor and the Division wherever you wanto to configure Climatization.

4. In Local Control:
4.1. In State: Select the Enable option to turn on the climatization system in the division.
4.2. In local temperature sensor, select the sensor that is in the division.
4.3. The graph allows you to control the local temperature in two modes: Cold Mode on top and on Heat Mode below. These two modes allow you to control the local temperature according to your needs.
The temperature graph includes 5 areas:
The central area is one where the temperature read is equal to the temperature selected by the customer.
The area that lies to the left of the central area is when the local temperature is 1 ° C below the desired temperature.
The area that is completely left of the center area is when the local temperature is 3 ° C below the desired temperature.
The area which is to the right of the central area is when the local temperature is 1 ° C above the desired temperature.
The area is totally located to the right of the central area is when the local temperature is above 3 ° C of the desired temperature.
4.4. For each of the two modes (Cold Mode) and (Heat Mode), you must define the actions to perform when on or off.
Clicking the ON button, you can set what is on / off when you turn on the air conditioning when it is in the selected mode.
Clicking the OFF button, you can define what is on / off when you turn off the air conditioning when it is in the selected mode.
4.5. In Devices to trigger when ..., press button : to add outputs;
In the Output Selection window, select the output you want.
Note: Some outputs allow you to specify the type of action, duration and type of execution.
To apply the features you preset click button: Ok.
To exit the window without saving your changes, click: Cancel.

To clear all the settings for the selected division press Clear All button.

5. In General Control:
5.1. In General Outside Temperature Sensor, set the sensor you want to use for reading the general temperature, which typically uses the iMeteo station of your home. This temperature is purely informative and does not affect the operation of your climatization.
5.2. You should define the actions to perform when the climatization is on or off. There is no direct way in the user area that allows running on or off the general climate, as the Power (ON) is executed when one of climatizações, one of the divisions, is turned on and off (OFF) runs when all the climatizações, all divisions are switched off.
Clicking the ON button, you can set what is on / off when you turn on the air conditioning when it is in the selected mode.
Clicking the OFF button, you can define what is on / off when you turn off the air conditioning when it is in the selected mode.
5.3. In Devices to trigger when ..., press button : to add outputs;
In the Output Selection window, select the output you want.
Note: Some outputs allow you to specify the type of action, duration and type of execution.

To apply the features you preset click button: Ok.
To exit the window without saving your changes, click: Cancel.
To clear all settings for the general control, press Clear All button.